Title page is generally a separate page and comes before the text of the manuscript. It should include following details in the given format & sequence:
Type the Title of Paper
First Author1, Second Author2, Third Author3
1. Department, Name of College / Institution / Organization, State, Country Email address
2. Department, Name of College / Institution / Organization, State, Country Email address
3. Department,Name of College / Institution / Organization, State, Country Email address
|These instructions are only a guide. Consistency and correct type area margins (see below) are the most important aspects in your manuscript preparation. All portions of the manuscript must be typed double-spaced and all pages numbered starting from the title page.|
|1. TEXT AND TYPE AREA (Margins)|
|This one basic requirement must be adhered to:
Type area on a page is standard A4( 8.5'' x 11''). All text should be fully justified. Margins for this type area: top 1.2'', bottom 0.6'' left 0.8'', right 0.6''
|2. TITLES FORMAT|
|Your chapter should begin with a brief Abstract and keywords.
Paper Title, Autor Names/Affiliations, Abstract and Kerywords should be in single column format followed by the rest of the paper in Single column format. Total number of authors allowed per paper is 5.
|Text type should be 10 point Times Roman. Text should be 1.5 lines spaced. First line of all paragraphs should be indented and there should be one line gap between consecutive paragraphs.|
|4. HEADS / SUB HEADS|
|Levels of subheads should be easily distinguishable from each other with the use of numbers. There should be one line spaces before each subhead and one line space after each subhead.|
|Examples of Subhead Style:
l. FIRST LEVEL HEAD
(11 point bold, upper case, numbered )
1.1. Second Level Subhead
(10 point bold, first letter capital case, numbered)
1.1.1. Third level subhead
(10 point bold, lower case, flush left)
|Use FIRST LEVEL SUBHEAD for section headings.|
|5. ORDER OF THE CONTENT
|The order of the content must be as per following sequence;
1. Title Page with Authors details (Including emails and affiliations)
2. Abstract & Keywords
4. Methods, if applicable / any
5. Results, if applicable / any
7.Acknowledgements, if applicable / any
9. Appendices (if applicable / any)
|The Title should be a brief phrase describing the contents of the paper. The Title Page should include the authors' full names and affiliations, the name of the corresponding author along with phone, fax and e-mail information. Present addresses of authors should appear as a footnote.|
|The Abstract should be informative and completely self-explanatory, briefly present the topic, state the scope of the experiments, indicate significant data, and point out major findings and conclusions. The abstract should be 100 to 200 words in length. Complete sentences, active verbs, and the third person should be used, and the abstract should be written in the past tense. Standard nomenclature should be used and abbreviations should be avoided. No literature should be cited.|
|8. FIGURES (Line Art Drawings) AND TABLES|
|FIGURES Figures and tables may appear printed directly in the text and should be black and white or grayscale. Figure should appear soon after the citation in the text or if it is too large at the end of the manuscript.
Legends/Captions for figures
Text type should be 9 point Times Roman italic (eg; Figure 1. Caption). A caption should be provided for each figure. The legend should be typed into the manuscript, directly beneath the figure. Begin each legend with a title and include sufficient description so that the figure is understandable without reading the text of the manuscript. Information given in legends should not be repeated in the text. Legends are to be listed in numerical order, labeled as “Figure 1”, “Figure 2”, etc.
TABLES Indent tables slightly from the left margin, if it is necessary to use the full width of the page. Tables should be kept to a minimum and be designed to be as simple as possible. Tables are to be typed double-spaced throughout, including headings and footnotes. Each table should be on a separate page, numbered consecutively in Arabic numerals and supplied with a heading and a legend. The same data should not be presented in both table and graph forms or repeated in the text.
Titles/Captions for tables The table caption should be typed to the width of the table itself and typed above the table. Text type of table caption should be 9 point Times Roman italic (e.g., Table 1.Caption). Number the titles of the tables consecutively in the order of their first citation in the text. Be sure that each table caption is headed as “Table 1”, “Table 2”, etc. within each chapter.
Both figures and tables must be cited in the text.
|Results should be presented with clarity and precision. The results should be written in the past tense when describing findings in the author(s)'s experiments. Previously published findings should be written in the present tense. Results should be explained, but largely without referring to the literature. Discussion, speculation and detailed interpretation of data should not be included in the results but should be put into the discussion section.|
|The Discussion should interpret the findings in view of the results obtained in this and in past studies on this topic. State the conclusions in a few sentences at the end of the paper. The Results and Discussion sections can include subheadings, and when appropriate, both sections can be combined.|
|References text type should be 10 point (Times Roman). In the text, a reference identified by means of an author‘s name should be followed by the date of the reference in parentheses. When there are more than two authors, only the first author‘s name should be mentioned, followed by ’et al‘. In the event that an author cited has had two or more works published during the same year, the reference, both in the text and in the reference list, should be identified by a lower case letter like ’a‘ and ’b‘ after the date to distinguish the works.
References must be according to APA style guidelines
J. K. Author, “Title of chapter in the book,” in Title of His Published Book, xth ed. City of Publisher, Country if not USA: Abbrev. of Publisher, year, ch. x, sec. x, pp. xxx–xxx.
R. L. Myer, “Parametric oscillators and nonlinear materials,” in Nonlinear Optics, vol. 4, P. G. Harper and B. S. Wherret, Eds. San Francisco, CA: Academic, 1977, pp. 47-160.
For PhD Thesis:
J. K. Author, “Title of thesis,” M.S. thesis, Abbrev. Dept., Abbrev. Univ., City of Univ., Abbrev. State, year.
J. K. Author, “Title of dissertation,” Ph.D. dissertation, Abbrev. Dept., Abbrev. Univ., City of Univ., Abbrev. State, year
J. O. Williams, “Narrow-band analyzer,” Ph.D. dissertation, Dept. Elect. Eng., Harvard Univ., Cambridge, MA, 1993
Article in a Journal:
J. K. Author, “Title of report,” Abbrev. Name of Co., City of Co., Abbrev. State, Rep. xxx, year.
E. E. Reber et al., “Oxygen absorption in the earth’s atmosphere,” Aerospace Corp., Los Angeles, CA, Tech. Rep. TR-0200 (4230-46)-3, Nov. 1988.
J. K. Author. (year, month day). Title (edition) [Type of medium]. Available: http://www.(URL)
J. Jones. (1991, May 10). Networks (2nd ed.) [Online]. Available: http://www.atm.com
Parallel Submission: Paper(s) once submitted to us should NOT be submitted in parallel to other companies to avoid confusion that would arise out of duplicate publication. If it is done, it will be at the risk of the authors who is submitting the manuscript and we as a publisher will not take any responsibility.
Plagiarism : We are calling for Original research papers ONLY for publication. We assume that there won't be any plagiarism related issues (having full trust on the authors) from the papers submitted by authors. This includes self plagiarism, the manuscript content should not be submitted/stored in any URL/Database/Website before submitting to us for publication.
If plagiarism is found during the course of publication process, the corresponding author will be notified along with plagiarism report. This plagiarism check / validation will be done for 2 times free of cost. Authors must use this opportunity to eradicate the plagiarism issues. From 3rd time onwards, it will be charged as ?500(For Indian authors) / $15 (for Foreign authors) per plagiarism check / validation. Once cleared, the article will be processed further.
Publication in 3rd party / collaborative journals : It is the responsibility of the authors of the manuscript who are submitting the paper, to validate and verify the authenticity and indexing of the 3rd party/collaborative journals before submission.
Note 1: As a publisher, we are responsible for the process of publication ONLY.
Note 2: Indexing is entirely dependent on content, indexing partner guidelines and their indexing procedures. Sometimes indexing happens immediately and sometimes, it takes time. The complete process for including any article (s) in the Scopus/Web of Science/Other database is done by the respective team only. Journal or Publication House is not involved in the decision-making regarding indexing and/or abstracting in any database and cannot influence the processing time of paper. Post-publication and indexing process, if for any reasons– extraneous circumstances, due to conflicts between journal publisher and indexing agency or due to non-adherence of ethical standards–, the indexing is rescinded/paper is removed from the database by the indexing agent (Scopus, Clarivate Analytics (formerly Thomson Reuters), etc.), we cannot be held responsible/accountable for the same.
Note 3: All SCOPUS/WOS journals do not provide certificates
Note 4: DOIs are publisher specific and all the publishers need not provide DOIs
Note 5: Please note that paper publication is influenced by extraneous elements. The time required for publication is affected, i.e. subject to increase or decrease, by extraneous elements. Publication House does not have control over these and will not be liable for any delay. If publication is cancelled due to extraneous elements, the fee will be refunded to the payer.